Anterior Cruciate Ligament Reconstruction Using a Mini-Arthrotomy Technique with Either an Ipsilateral or a Contralateral Autogenous Patellar Tendon Graft

Chapter 49 Anterior Cruciate Ligament Reconstruction Using a Mini-Arthrotomy Technique with Either an Ipsilateral or a Contralateral Autogenous Patellar Tendon Graft




Introduction


There are many techniques for anterior cruciate ligament (ACL) reconstruction that involve using different surgical instruments, graft choices, fixation devices, and postoperative care. Each surgeon needs to become an expert at one technique, track the patients’ results, and then make refinements in the surgery and rehabilitation to optimize outcomes. It is important to note that ACL surgery is not just a surgery but also involves specific preoperative and postoperative rehabilitation programs to obtain a good result. Specific rehabilitation guidelines will be covered in other chapters in this book. The purpose of this chapter is to describe a technique for ACL reconstruction using autogenous patellar tendon graft from either the ipsilateral or contralateral knee.


In the past 24 years, I have performed more than 5000 ACL reconstructions, and I have always used an autogenous patellar tendon graft for all the surgeries. I prefer to use the patellar tendon graft because it allows for quick and predictable bone-to-bone healing, is viable throughout the entire postoperative course,1 and can respond to stress during rehabilitation. Although any biological graft that is properly placed in the knee can achieve the same stability after surgery, the patellar tendon graft may allow for the fastest postoperative rehabilitation program because bone–bone healing is quicker than tendon–bone healing. Regardless of graft choice, proper rehabilitation must be done to give the best result.



Preoperative planning



Radiographs


Radiographs are obtained preoperatively to assist with surgery planning.


Plain radiographs, including standing posteroanterior 45 degrees flexed weight bearing,2 lateral, and Merchant3 views are obtained. The radiographs allow us to measure the width of the intercondylar notch, length of the patellar tendon, tibial slope angle, and width of the patella, which is usually twice the width of the patellar tendon. These measurements are helpful for planning the angle and length of the femoral tunnel and help determine the amount of notchplasty that may be needed to accommodate for the width of the new ACL graft. A magnetic resonance imaging (MRI) scan is not necessary for our preoperative evaluation but is reviewed if it has already been obtained elsewhere.



Rehabilitation


There is never a reason to do an isolated ACL reconstruction as an emergency surgery. Previous studies have shown that acute ACL reconstruction has a higher rate of postoperative arthrofibrosis than delayed ACL reconstruction when the patient has the opportunity to undergo rehabilitation to allow the knee to return to a quiescent state.4,5 All patients are evaluated by a physical therapist at the time of my initial evaluation. The physical therapist measures knee range of motion and strength before surgery and determines when the patient is ready to undergo surgery. The patient must have full knee range of motion equal to the contralateral normal knee, good leg control, and no knee swelling before he or she can undergo surgery. Furthermore, the patient must be mentally prepared for surgery. The surgery and rehabilitation program are fully explained to the patient and his or her caregiver so that they fully understand what is expected of them after surgery. The surgery date is planned for a time when the patient has at least 1 week off school or work and when a family member or friend can be at home with him or her during the first week postoperatively.



Technique








Femoral Exposure


The patellar tendon length is determined preoperatively from a 60-degree-flexion lateral plain radiograph. The length of the tendon varies from 34 to 74 mm (mean 49 mm for men and 46 mm for women). Longer patellar tendons need longer femoral tunnels. The intraarticular ACL length varies from 22 to 30 mm, so the extra length of the graft is placed in the femur. The bone plug in the tibia is placed just distal to the medial tibial spine because the only hard cancellous bone in the tibia is at the proximal joint line. The femoral tunnel exit site is adjusted based on the length of the graft. For longer patellar tendons, the incision will be made more proximally; for shorter patellar tendons, the incision is made more distally. In our experience, an oblique incision has resulted in fewer wound-healing problems than a longitudinal incision in line with the iliotibial band.


The table is elevated so that the femur is close to eye level. The foot of the bed is lowered so that the knee is flexed to 90 degrees. The bump under the thigh may need to be adjusted to allow for 90 degrees of flexion. The goal is to expose the flat surface of the lateral femoral cortex above the metaphyseal flare. The 3-cm lateral oblique incision is made about 4 to 5 cm above the superior pole of the patella along Langer’s lines (Fig. 49-3

Only gold members can continue reading. Log In or Register to continue

Stay updated, free articles. Join our Telegram channel

Mar 9, 2016 | Posted by in Reconstructive surgery | Comments Off on Anterior Cruciate Ligament Reconstruction Using a Mini-Arthrotomy Technique with Either an Ipsilateral or a Contralateral Autogenous Patellar Tendon Graft

Full access? Get Clinical Tree

Get Clinical Tree app for offline access